How to apply a phone skin
Take a few minutes to prepare your phone and apply the skin gradually. Have a cleaning wipe, dust-removal sticker, microfiber cloth and card ready.
1. Clean the surface
- Turn off your phone so you can handle it without accidental screen presses.
- Clean the back with an isopropyl alcohol wipe or a microfiber cloth lightly dampened with cleaner. Remove grease and fingerprints.
- Lift away dust with adhesive tape or a dust-removal sticker. Dust trapped under the skin can cause a bubble.
2. Peel back only the top
- Do not remove the entire backing at once.
- Carefully peel back the top 2 to 3 cm of the skin. Fold the backing paper behind it to expose the adhesive strip.
3. Align the skin
- Use the rear camera module and the top edges of the phone as guides.
- Lightly press down the exposed strip once it is aligned. If it sits crooked, gently lift it right away and adjust it.
4. Apply it gradually
- Wrap a firm card or soft squeegee in a microfiber cloth to avoid scratching the surface.
- Slowly pull away the remaining backing as you work down the phone. Smooth from the center towards the outer edges to push out air and prevent bubbles.
5. Finish the edges and corners
- Warm the edges and corners with a hair dryer for 5 to 10 seconds on a moderate setting.
- Press the rounded corners firmly with a finger or cloth so the skin follows the curves of the phone and stays in place.